Brinkmann 810-7405-S Para El Instalador página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION: Some parts may
contain sharp edges. Wear
protective gloves if necessary.
Step 5
Using the one of the gas orifice tool
provided remove the LP brass
orifice from the tip of each gas valve
assembly.
Note: All orifices of the grill, except
rotisserie, are double orifices
type (LP gas and natural gas).
You only remove the LP gas
orifice tip.
Step 6
Remove all the control knobs from the
control panel and set aside for later
use.
Step 7
Figure 1 shows valve stem and bezel
with both screws. Place stop plate over
valve stem as shown in Figure 2. Verify
the tab and the stamped letter on the
stop plates face out. Replace control
knobs when finished.
WARNING: We recommend and
request that you do not remove the
control panel in order to access the
valve tips. If you choose to remove
the control panel, you must replace
the control panel bezels exactly as
illustrated in Figure 2. Failure to
replace the bezels as illustrated
could lead to personal injury and/or
property damage.
11
Side View
LP Gas Orifice
Tab
Figure 1
Fire Box Front Panel
Wrench
Stop Plate
Stop Pin
Figure 2

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido