Brinkmann 810-7405-S Para El Instalador página 16

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Step 7
Figure 1 shows valve stem and bezel
with the control knob removed. Take
five large stop plates from the
component card and place them over
the main and side burner valve stems
as illustrated (Figure 2). Take the small
stop plate from the component card
and place it over the rotisserie burner
valve stem (Figure 3). Verify the tab
and the stamped letter on the stop
plates face out. Replace control knobs
when finished.
WARNING: We recommend and
request that you do not remove the
control panel in order to access the
valve tips. If you choose to remove
the control panel, you must replace
the control panel bezels exactly as
illustrated in Figure 2. Failure to
replace the bezels as illustrated
could lead to personal injury and/or
property damage.
Step 8
Carefully replace each burner,
making sure burner openings slide
over valve nozzles. Screw each main
burner "foot" down using screwdriver
and screws that were set aside in
Step 4. Replace cotter pin in side
burner "foot" that were set aside in
Step 2.
Step 9
Replace warming rack, cooking grills,
heat shields and grease tray.
Note: Follow directions in the leak
testing section of this manual
before using this grill.
15
Tab
Figure 1
Tab
Figure 3
Stop Plate
Stop Pin
Figure 2
Stop Plate
Stop Pin
Warming Rack
Cooking Grills
Heat Shields

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido