Publicidad
Idiomas disponibles
Idiomas disponibles
AFTER CLEANING
Unplug
carpet
cleaner
from
electrical
outlet.
1. Empty
any
water
that
remains
in
the
Clean
Water
Tank.
2. If the
cleaner
will
be
stored
for
an
extended
period
of time
empty
the
Detergent
Tank.
3. Empty
the
Dirty Water
Recovery
Tank.
a.
Lower
cleaner
handle
to the floor.
b. Grasp
handle
of Dirty
Water
Recovery
Tank
and pull straight
up.
c.
Set tank
on counter-top
or table.
d.
Remove
lid by
pushing
button
and
pivoting
the lid up and back.
e.
Dump
dirty
water
in sink
or toilet.
f.
Rinse
tank
and screen.
g.
Rinse
lid.
h.
Secure
lid to tank.
i.
Place
tank
into
cleaner.
4. Clean
the Recovery
Nozzle
a.
Dirty
Water
Recovery
Tank
must
be removed
before
removing
Recovery
Nozzle
(Fig. 4.7).
b.
Push
SpotFinder
headlight
towards
back
of
cleaner
c.
Lift
top
of Recovery
Nozzle
and
pivot
away
from
cleaner
d.
Pull
recovery
nozzle
away
from
latches
on
the bottom
of the cleaner
e.
Take
to sink
and
rinse
with
clean
water
until
debris
is removed
(Fig. 4.8).
f.
Lift bottom
of cleaner
2 inches
off the floor
and
re-attach
nozzle.
Use
Iocator
tabs
(A) to hinge
on nozzle.
g.
Push
SpotFinder
headlight
towards
back
of
cleaner
h.
Pivot
Recovery
Nozzle
towards
cleaner.
i.
Release
SpotFinder
headlight
to secure
nozzle.
5. Clean
the SpinScrub
TM
brushes.
a.
Lift base
of cleaner
from
floor.
b.
Grasp
each
end
of
SpinScrub
TM
brush
assembly.
c.
Pull away
from
cleaner
(Fig. 4.9).
d.
Rinse
with
water
until debris
is removed.
e.
To replace,
align SpinScrub
TM
shaft with
hole.
f.
Align
SpinScrub
TM
guides
with
posts
on
cleaner
g.
Push
SpinScrub
TM
assembly
towards
cleaner
6. For
best
results,
all parts
should
be
allowed
to
dry before
storing
cleaner
7. Do
not
store
cleaner
where
temperatures
could
drop
below
freezing
_32°F, 0!0),
Publicidad
