Liability; Installation; Assembly; Tube Preparation - SOMFY Sunea Screen 40 io Manual De Instrucciones

EN

1.2 LIABILITY

Please read these instructions carefully before installing and using the drive. In addition to following the instructions given in this guide,
the instructions detailed in the attached Safety instructions must also be observed.
The drive must be installed by a drive and home automation professional, according to Somfy instructions and the
regulations applicable in the country in which it is commissioned.
It is prohibited to use the drive outside the field of application described above. Such use, and any failure to comply with the instructions
given in this guide and in the attached Safety instructions document, absolves Somfy of any liability and invalidates the warranty.
The installer must inform his customers of the operating and maintenance conditions for the drive and must provide them with the
instructions for use and maintenance, as well as the attached Safety instructions document, a er installing the drive. Any A er-Sales
Service operation on the drive must be performed by a drive and home automation professional.
If in doubt when installing the drive, or to obtain additional information, contact a Somfy adviser or go to the website www.somfy.com.
Safety warning!

2. INSTALLATION

These instructions are mandatory for the drive and home automation professional installing the drive.
Never drop, knock, drill or submerge the drive.
Install a separate control point for each drive.

2.1. ASSEMBLY

2.1.1. Preparing the drive
Check that the inner diameter of the tube is 37 mm or greater.
1) Fit the accessories required to integrate the drive into the roller tube:
• Either fit the drive wheel a on the drive.
• Or fit the crown b and the drive wheel c on the drive.
2) Measure the length (L1) between the inner edge of the drive head and the rim of
the drive wheel.

2.1.2. Tube preparation

1) Cut the roller tube to the required length, depending on the motorised product.
2) Deburr the roller tube and remove the swarf.
3) For roller tubes which are smooth inside, cut a notch with the following
measurements:
24
Caution!
Ø 40 x 1
Ø 40 x 1.5
Images not contractually binding
Λ
Information Up
1)
2)
1)
3)
d e
6 mm 8.5 mm
7 mm 8.5 mm
V
Down
Ø = 37 mm
a
L1 = ...
L1
2)
d
Copyright © 2016 Somfy SAS. All rights reserved.
Ø > 37 mm
b c
e