Commissioning; Checking The Direction Of Rotation; Setting The End Limits - SOMFY Sunea Screen 40 io Manual De Instrucciones

EN

2.3. COMMISSIONING

2.3.1. Preprogramming the control point
1) Switch on the power supply.
2) Press the Λ / V buttons on the control point at the same time: The motorised
product makes up and down movements (rapidly raising and lowering), and the
control point is pre-programmed in the motor.
The drive is in programming mode for ≈ 10 min.

2.3.2. Checking the direction of rotation

1) Press the Λ button on the control point:
a) If the motorised product rises (a), the direction of rotation is correct: Move
onto the section entitled "Setting the end limits".
b) If the motorised product lowers (b), the direction of rotation is incorrect:
Move onto the next step.
2) Press the my button on the control point until the motorised product moves up and
down: the rotational direction has been modified.
3) Press the Λ button on the control point to check the direction of rotation.

2.3.3. Setting the end limits

Limit position setting in manual mode
For vertical awnings without upper stop, or lateral arm-mounted awnings without head rail, both end limits may be modified.
The end limits can be set in any order.
1) Raise the motorised product to the desired position by pressing the Λ button.
2) Press the my and V buttons at the same time until the motorised product moves.
The upper end limit is memorised.
3) Press the my button when the motorised product reaches the desired lowered
position. If necessary, adjust the position of the motorised product using the Λ and
V buttons.
4) Press the my and Λ buttons at the same time until the motorised product moves.
The lower end limit is memorised. The motorised product rises and stops in the
raised position.
5) To confirm the end limits, press the my button until the motorised product moves
up and down.
The end limits are programmed.
26
Images not contractually binding
1 2
ON
1
Setting the end
a
b
onto the next step
2 3
1 2
4
3
5
Copyright © 2016 Somfy SAS. All rights reserved.
limits
Move