Wiring - SOMFY Sunea Screen 40 io Manual De Instrucciones

2.1.3. Drive/tube assembly
1) Slide the drive into the roller tube.
For roller tubes which are smooth inside, position the notch previously cut on the boss
on the crown.
2) Fix the roller tube on the drive wheel using the screws or pop rivets depending on
the length (L1).
The screws or pop rivets must only be fastened onto the wheel and not on the
drive.
2.1.4. Installing the drive/tube assembly
Fit and attach the tube/drive assembly to the end support (f) and the drive support (g):
1)
Ensure that the drive/tube assembly is secured onto the end bracket. This
operation prevents the tube/drive assembly from coming out of the end
bracket attachment.
Depending on the type of bracket, screw the adapter onto the motor head.
2)

2.2. WIRING

Standard NF C 15-100 for electrical installations must be adhered to.
Cables which pass through a metal wall must be protected and insulated using a sheath or sleeve.
Attach cables to prevent any contact with moving parts.
If the drive is used outdoors and if the power supply cable is of the H05-VVF type, route the cable in a UV-resistant duct, e.g.
trunking.
The io Sunea Screen 40 cable cannot be removed. If it is damaged, return the drive to the A er-Sales department.
Always make a loop in the power supply cable to prevent water entering the drive!
Leave the drive power supply cable accessible: it must be easily replaceable.
Switch off the power supply.
-
Connect the drive according to the information in the table below:
-
230 V 50 Hz
Copyright © 2016 Somfy SAS. All rights reserved.
Neutral (N) Live (L)
Blue Brown
1)
2)
Earth ( )
-
Images not contractually binding
L1
1)
g
2)
h
OFF
N L
230 V 50 Hz
EN
f
25