Optional Accessories - Makita DML811 Manual De Instrucciones

Linterna de trabajo inalámbrica
Ocultar thumbs Ver también para DML811:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION:
• Insert the female plug into the appliance first
completely, then connect the male plug to an outlet.
• Always close the socket cover firmly when the power
cord is not plugged.
NOTE: The AC power does not charge the battery
inserted to the appliance.
NOTE: Even operating in DC power, the appliance
automatically changes to AC power when the power cord
is plugged in.
Organizing the power cord:
Coil power cord on stand tightly, then clip end of the cord
by using fastener attached. (Fig. 5)
Turning on the light and brightness mode selection
(Fig. 6)
1. Switch : Press the switch once, the light turns on (At
the same brightness mode as the last setting). Press the
switch again, the light turns off.
2. Brightness mode selection: Brightness sequence is :
High mode / Mid mode / Low mode / High mode for each
press when the light is on.
Battery protection system (Fig. 7)
The appliance is equipped with a battery protection
system to extend battery life. When the battery becomes
low, the LED lights go out except one LED as illustrated.
Then approximately five to ten minutes later, the system
automatically cuts off power.
OPERATION
CAUTION:
• This light is intended for commercial use. Do not use
the light for household purpose.
• Always put the appliance on flat and stable place.
Otherwise a falling accident may occur.
Adjusting the angle of the light (Fig. 8)
Loosen the knobs on the both side. Adjust the angle of
the light (adjustment range is 240°). Then tighten the
knobs again.
CAUTION:
Take care not to trap finger(s) when adjusting the angle
of the light.
Using with tripod (optional accessories)
CAUTION:
• Read carefully the instruction manuals of the
accessories before using them with the light.
You can put the light on the tripod to facilitate the
operation. (Fig. 9)
CAUTION:
• Be careful not to drop the appliance when attaching
the appliance on the tripod.
• Place the tripod on a level and stable surface to
prevent from falling.
• Spread the legs of the tripod to the maximum.
• Do not use the tripod if the wind is strong.
• Make sure that the appliance is attached securely on
the tripod.
• Remove the appliance when carrying the tripod or
when folding the legs of the tripod.
• Be careful not to get your hand caught in the legs of
the triopd when closing the tripod.
8
MAINTENANCE
CAUTION:
• Always be sure that the appliance is switched off,
unplugged, and the battery cartridge is removed before
attempting to perform inspection or maintenance.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Only maintenance work described in this instruction
manual may be performed by the user. Any other work
must be carried out by Makita authorized service centers.
Cleaning
CAUTION:
• Never wash the appliance in water.
From time to time wipe off the outside (appliance body) of
the appliance using a cloth dampened in soapy water.

OPTIONAL ACCESSORIES

CAUTION:
• These accessories or attachments are recommended
for use with your Makita appliance specified in
this manual. The use of any other accessories or
attachments might present a risk of injury to persons.
Only use accessory or attachment for its stated
purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita service center.
• Makita genuine battery and charger
• Tripod [Part No:GM00002073]
NOTE:
• Some items in the list may be included in the
appliance package as standard accessories. They
may differ from country to country.
MAKITA LIMITED ONE YEAR WARRANTY
Warranty Policy
Every Makita appliance is thoroughly inspected and
tested before leaving the factory. It is warranted to be
free of defects from workmanship and materials for the
period of ONE YEAR from the date of original purchase.
Should any trouble develop during this one year period,
return the COMPLETE appliance, freight prepaid, to
one of Makita's Factory or Authorized Service Centers.
If inspection shows the trouble is caused by defective
workmanship or material, Makita will repair (or at our
option, replace) without charge.
This Warranty does not apply where:
• repairs have been made or attempted by others:
• repairs are required because of normal wear and tear:
• the appliance has been abused, misused or improperly
maintained:
• alterations have been made to the appliance.
IN NO EVENT SHALL MAKITA BE LIABLE FOR ANY
INDIRECT, INCIDENTAL OR CONSEQUENTIAL
DAMAGES FROM THE SALE OR USE OF THE
PRODUCT. THIS DISCLAIMER APPLIES BOTH
DURING AND AFTER THE TERM OF THIS WARRANTY.
MAKITA DISCLAIMS LIABILITY FOR ANY IMPLIED
WARRANTIES, INCLUDING IMPLIED WARRANTIES OF
"MERCHANTABILITY" AND "FITNESS FOR A SPECIFIC
PURPOSE," AFTER THE ONE YEAR TERM OF THIS
WARRANTY.

Publicidad

Tabla de contenido
loading

Tabla de contenido