TECshow HALO 7R Manual De Usuario página 5

Encoder Pan-Tilt
No DMX Signal
Display Power Save
Burn on start up
Load Default
Information interface
Option
Total using time
The use of time
System errors logs
After you finish view
Manual control interface
This interface use to control present light, nei-
ther belong to the from the machine state (didn't
received DMX signal), nor belong to Host state (send
DMX signal).
Option
Reset Press ok key see the confirmation dialog box, again press ok key, enter the reset interface,
all motor reset.
Color Wheel 0-255
...... 0-255
The speed of
0-255
gobo wheel
ON
Bulb control
OFF
NO Use encoder correct position.
OFF Do not use encoder correct position.
KEEP According to the original state continues to run.
CLEAR The return of the motor, stop running.
OFF Free 30 seconds after closing backlight.
ON Backlight ever bright.
Power on directly after reset, no light bulb (need to use the menu or
OFF
control table to manual light bubble).
After power on automatic light bubble, must wait for the light bulb light
NO
up success can be reset.
Press ok key see the confirmation dialog box, again press ok key, Press
OK key into edit.
Cumulative using time (Accuracy to the minute).
Use of time since the boot (Accuracy to the minute).
If the red indicator shine ,that mean the lamps runs error. The details can be
entered sub-interface to view.
You can press the "OK" key to make the error log empty. Pay attention: Some-
times not the Hall or optical coupler installation problems, But the motor cable is
connected backwards.
Press OK key into edit state, its selected hundred. Press up or down,change
channel value .Press again OK key, selected ten editor. Press again OK key,
select the edit. Press it again to exit the edit state.
Instruction
Instruction
P. 5
| Tecshow Halo R7
English version