Main Interface - TECshow HALO 7R Manual De Usuario

3. MENU

Main Interface

Top right corner 3 button for language switching
and screen rotation.
Bottom row four button corresponding sub inter-
face is introduced, it's in the back.
With touch operating mode sub interface is intro-
duced.
Set up the interface
Option
Run Mode
DMX Address
Channel Mode
Invert Pan
Invert Tilt
Swap Pan-Tilt
P. 4
Tecshow Halo 7R | English version
DMX Slave state: Accept control table or main engine.
Statistics: Automatic operation and send DMX signal for slave Note: If
the bulb is put out before, the light bulb will not be full light. If you need
Automatic
to observe the lighting effects, please keep the light on, and then into
the automatic state.
Press OK key into edit state, its selected hundred. Press up or down,
1-512
change address code. Press again OK key, selected ten editor. Press
again OK key, select the edit. Press it again to exit the edit state.
16 The 17th to 20th channels are invalid.
20 Control speed of the 17th to 20th channels (see the channel list).
OFF
NO
OFF
ON
OFF
NO Change the channel of XY axis (include trimming).
Instruction