Briggs & Stratton 020228 Manual Del Propietário página 12

Section 4: Operation
For maximum rinsing (higher pressure and lower
fiow)_ for stubborn or hard to reach surface such
as second story surfaces, paint removal, oil stains_
rust removal or other stubborn substances (tar,
gum, grease_ wax_ etc.)_ select red Hax
ProjectPro TMnozzle (Figure IS).
To apply detergenL applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black ProjectPro TM
cleaning detergent nozzle (Figure 16).
Now to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern.Always start the turbo nozzle at a
distance, gradually getting closer to the surface until you
get the cleaning force you want.
CAUTION
Always make sure the surface you will clean wiJJ not be
damaged by the high pressure spray by testing in a hidden area,
I. Pull back collar on quick-connect and pull current
ProjectPro TM nozzle off. Store ProjectPro TM nozzles in
holder provided on the accessory tray.
2. Pull back on collar, insert turbo nozzle and release
collar (Figure 17).Tug on turbo nozzle to make sure it
is
securely in place.
3. For most effective cleaning, keep turbo nozzle from 8 to
24 inches away from cleaning surface. If you get turbo
nozzle too close_ you may damage cleaning surface.
NOTE: Detergent cannot be applied with the turbo
nozzle.
aeaning and Applying Detergent
iMPORTANT: Use detergents designed specifically
for pressure washers. Household detergents could
4. Pull back on collar, insert new PrqectPro TM nozzle and
release collar.Tug on ProjectPro TM nozzle to make sure
it is securely in place.
5. For most effective cleaning, keep ProjectPro TM nozzle
from 8 to 24 inches away from cleaning surface. If you
get ProjectPro TM nozzle too close,you may damage
cleaning surface.
6. DO NOT get closer than 6 inches when cleaning tires.
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from f_ihJre to follow this
instruction will void warranty.
To apply detergent follow these steps:
I. Review ProjectPro TM nozzle use.
2. Prepare detergent solution as required by
manufacturer.