Briggs & Stratton 020228 Manual Del Propietário página 6

ASSEMBLY
iMPORTANT: Read entire owner's manuai before you
attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From
H. Remove the parts
bag, accessoNes,
and inserts inciuded
with pressure washer.
2. SHice two corners at the end of carton from top to
bottom so the panei can be foided down fiat.
3. Remove pressure washer from carton.
Carton Contents
items in the carton include:
Hain Unit
Handle
High Pressure Hose
Spray Gun
Nozzie Extension with Quick Connect Fitting
Piastic Accessory Tray
Safety Go_les
OH Bottle
Turbo Nozzle with Quick Connect
Parts Bag (which includes the following):
Owner's Hanual
Engine Hanual
Owner's Registration Card
Bag containing 4 multi-colored ProjectPro TM
Nozzles
Handle/Tray Fastening Hardware Kit (which
inciudes):
Carriage Bolts (2)
Piastic Knobs (2)
Tree Clips (4)
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, cail the
pressure washer helpline at J-8e0-743-41 l S. If calling for
assistance, please have the model revision, and serial
number from the data tag available.
To prepare your pressure washer for operation, you
will need
to
perform these tasks:
I. Fill out and send in registration card.
2. Attach handle to main unit, then attach accessory tray
to handle.
3. Add oii to engine crankcase.
4. Add fuel to fuel tank.
S. Connect high pressure hose to spray gun and pump.
6. Connect water suppiy to pump.
7. Attach nozzle extension to spray gun.
8. Selecdattach quick connect ProjectPro TMnozzle to
nozzle extension.
Attach
Handle and Accessory Tray
l, Place handle onto handle supports connected to main
unit. Hake sure holes in handle align with holes on
handle supports (Figure I).
NOTE:
It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports,
0