Briggs & Stratton 020228 Manual Del Propietário página 17

Storage
PREPARING THE fJNmT
FOP, STORAGE
VVater shouHd not remain in the unit for Hong periods of
time. Sediments or mineraHs can deposit on pump parts and
"freeze" pump action. If you do not pHanto use the pressure
washer for more than 30 days_follow this procedure:
H. Hush chemicaH injection hose by pHadng fiker into a paiH
of dean water whiHe running pressure washer in How
pressure mode. Hush for one to two minutes.
2. Shut off engine and Het it cool then remove high
pressure and garden hoses. Disconnect spark pHugwire
from spark pHug.
3. Empty pump of aHH pumped Hiquids by puHHing recoiH
handHe about 6 times.This shouHd remove most Hiquid
in pump.
4. Use PumpSaver to prevent corrosion buiHd up and
freezing of pump.
5. Store unit in a cHean_ dry area.
Protecting the Pum
To protect the pump from damage caused by minera[
deposits or freezing, use PumpSaver to treat pump.This
prevents freeze damage and Hubricates pistons and seaHs.
NOTE: PumpSaver is available as an optionaH accessory. It
is not incHuded with the pressure washer. Contact the
nearest authorized service center to purchase PumpSaver.
• Failure to do so will permanently damage your pump and
render your unit inoperable,
• Freeze damage is not covered under warranty.
CAUTION
Always wear eye protection when using PumpSave_:
. Protect surfacesfrom dripping PumpSaver_
To use PumpSaven make sure the pressure washer is
turned off and disconnected from suppHy water. Read and
follow aHH instructions and warnings given on the PumpSaver
container.
NOTE:
[f PumpSaver is not available, draw RV antifreeze
(non=aHcohoH) into the pump by pouring the soHution into a
3=foot section of garden hose connected to inHet adapter
and puHHingrecoiH handHe twice.
STORING THE ENGINE
See the engine owner's manual for instructions on how to
properHy prepare the engine for storage.