G.program List; H.cycle Counter - Panasonic NE-2156-2 Manual De Instrucciones

For selecting length of tone "short beeps for 60 seconds":
Example: To select short beeps for 60 seconds
PAD
Follow step 1-4 on page 9. DO NOT CLOSE THE DOOR!
5
Within three seconds after pressing Prog pad at step 4, press
0
Number/Memory pad "0" once.
"PROG" will start to blink and 2nd Stage Heating Indicator "2" (the
length of beep tone "short beeps for 60 seconds") will be indicated.
6
Press Prog pad.
"PROG" will stop blinking. This means that you have completed
programming.
Three seconds later, "0" will appear.
• Close the door. One minute later, Digital Display Window will go blank.
G. PROGRAM LIST
PAD
1
Open the door and leave it open.
The oven lamp will turn on and "0" will appear.
2
While pressing Stop/Reset pad, press Start pad.
+
All currently programmed information (the program set into each
Number/Memory pad (A/B sides), Beep Tone, and Program Lock
information) will continuously appear.
H. CYCLE COUNTER
To Read The Number of Times Each Memory Pad Has Been Used:
Example: To read times of Number/Memory pad "3" at A side (6666 times used)
PAD
1
Open the door and leave it open.
The oven lamp will turn on and "0" will appear.
2
While pressing Stop/Reset pad, press Number/Memory pad "3".
3
+
The times that the pressed Number/Memory pad has been used will
appear.
Note:
• When you want to read the times of each pad at B side, press Shift (A/B) pad while the display is still showing
the number of cycles in step 2.
How to Operate
INSTRUCTION
INSTRUCTION
INSTRUCTION
NE-2156-2/NE-1656
- 11 -
DIGITAL DISPLAY WINDOW
PROG
1
PROG
2
PROG
2
DIGITAL DISPLAY WINDOW
e.g.
PROG
1
PROG
1
PROG
2
PROG
DIGITAL DISPLAY WINDOW
e.g.