Turning The Compressor On And Off - Invacare HomeFill II Oxygen System IOH200AW Manual Del Usuario

Invacare® HomeFill® II Oxygen System
5. When the cylinder fillport is disconnected from the connector
fillport, release the outer ring (sleeve) of the connector fillport
and use two hands to remove the cylinder from the compressor
cradle.
WARNING!
– The fillport cover on the connector fillport and
the cylinder fillport MUST be replaced after
filling and whenever not in use. If either of the
fillport covers are missing contact your healthcare
provider before using.
22
6. Place the fillport covers onto the connector fillport G and
cylinder fillport H.
When using the post valve type cylinder, attach an
oxygen regulator per manufacturers instructions.
7. Examine the cylinder gauge to ensure cylinder is full (needle
pointing into GREEN area). If the cylinder is not full, perform
the following:
a. Repeat Connecting the Cylinder to the Compressor, in this
section of the manual.
b. If cylinder is not full after second attempt to fill, contact the
provider.

4.5 Turning the Compressor On and Off

1195663-A