Tabla de contenido
Publicidad
34
monty 3300 RACING AT
5.1-0
5.1-1
5.1-2
5.1-3
5.1 Demounting tubeless tires
• Remove all wheel-weights from the rim. Remove the
valve stem or core and deflate the tire (Fig. 5.1-0).
NOTE: If the tire is over 13" (340 mm) wide, first set
the bead breaker in the "Wide" position
as follow:
1) Pull up and hold pin (1, Fig. 5.1-1), and pull the
bead breaker assembly in the "Wide" position.
2) Insert pin again (1, Fig. 5.1-1) in its hole to lock
the bead breaker in the new position.
535.a.tif
• Break outer bead starting from opposite the valve
position. lubricate the bead and rim with a tire lube
only. Break inner bead. Do not hold the foot pedal
depressed longer than necessary since this could
damage the bead. Liberally lubricate bead and rim
(Fig. 5.1-2).
Locking Rims
• Set the rim clamps to the proper position: retract
clamps to clamp the wheel from the inside and
expand clamps to clamp from the outside. When
clamping small wheels (14" or smaller) from the
outside, set the clamps at diameter nearly equal to
the rim diameter, before placing the wheel on the
clamps. This will avoid the risk of pinching the tire.
TO MINIMIZE THE RISK OF SCRATCHING ALLOY
RIMS, THESE SHOULD BE CLAMPED FROM THE
OUTSIDE.
• Liberally lubricate bead and rim.
• Place the wheel WITH DROP CENTER UPWARDS
(Fig. 5.1-3) on the turntable, and clamp in position.
330.tif
331.tif
Operator's Manual
USA - CANADA
Publicidad
Tabla de contenido
