Mounting The Ceramill Blank Holder For Rotational Milling - Amann Girrbach ceramill motion 2 Instrucciones De Uso

C A L I B R A T I N G T H E B L A N K H O L D E R
3.3.4 Mounting the Ceramill blank holder for
rotational milling
E N
NOTE:
When assembling, the anti-rotation bolt in the
blank holder must be in the provided groove in
the calibration sleeve.
▷ Avoid jamming/wedging!
▷ Carefully mount the blank holder onto the cali-
bration sleeve of the tool holder and firmly
screw together with the two provided screws
using a size 3 Allen key.
After screwing the blank holder and the
tool holder together, a small gap will
remain, which is negligible.
The Ceramill blank holder for rotational
milling can only be used for this machine.
▷ Make an appropriate mark on the blank
holder.
26
Fig. 14