myaudioart MA3 Manual De Instrucciones página 47

Removing and replacing the fabric covering
You can also remove the fabric covering to use a different motif.
ATTENTION
To facilitate removing the covering, an assembly tool is included in the delivery scope
of the system.
Removing the fabric covering
– Run one finger along the back of the frame on the side of the system where the
LEDs are. About one hand's breadth away from the corner you will be able to feel
a small hole (1) in the frame.
front view
– Introduce the straight end (2) of the assembly tool in the hole from the rear and pull
the bent end (3) of the assembly tool forward. The fabric covering must be pushed
out of the front of the frame.
– Grasp the slightly protruding fabric covering gently between thumb and index finger
and slowly pull it out of the frame.
– Pull the fabric covering completely out of the frame and put it on a smooth surface
without folding or bending it.
– Carefully separate the fleece and slowly remove it from the hook and loop strips.
Put it down without folding or bending it.
User Manual
Risk of damage!
Only use original AudioArt fabric coverings. Other fabric
coverings can cause damage to the system, for example
through overheating.
2
1
3
47