myaudioart MA3 Manual De Instrucciones página 48

Replacing the fabric covering
First place the fleece and then the fabric covering into the frame.
– Straighten the fleece on the top edge of the frame and press it at one corner onto
the hook and loop strip on the frame.
– Slightly smoothen the fleece on the opposite corner and press it onto the hook and
loop strip at that corner.
– Press the fleece on all the hook and loop strips one after another.
– Insert the rubber strips (1) of the fabric covering into one of the upper corners of the
frame (2). Make sure that the print is on the outside.
1
– Insert the rubber strips into the other upper corner of the frame.
– Insert the rubber strips into the two bottom corners of the frame.
– Slide the rubber strips along the edges inside the frame until the fabric cover lies
smoothly at every point.
48
2
User Manual