Kobalt XC802000 Manual Del Usuario página 10

INSTALLATION INSTRUCTIONS
WIRING
Local electrical wiring codes differ from area to area.
Source wiring and protector must be rated for at least the
amperage and voltage indicated on the motor nameplate
and meet all electrical codes for this minimum. Use
a slow blow fuse type T or a 240 Volt double pole
circuit breaker.
MINIMUM WIRE SIZES
(must meet all codes)
Up to 75 ft. long
1. Inspect the source
wiring before
continuing with
installation. Confirm
voltage with volt
meter line-to-ground
(shown in Figure 4).
Volt meter should
read 120 Volts.
Confirm voltage with
volt meter line-to-line
Volt meter should
read 230 / 240 Volts
(shown in Figure 5).
10 AWG
4
Volt Meter -
120 Volts
5
Volt Meter -
230 / 240 Volts
10
Line Wire
Line Wire
Ground Wire
Line Wire
Line Wire
Ground Wire