5. Initial use
• Remove the packaging material.
• Check that all parts listed are present.
• Check the device, mains adapter and mains cable for
damage.
• Remove the battery compartment lid on the underside of
the device and insert the batteries with the correct polar-
ity. The batteries supply power to the device in the event
of a power failure.
• Place the device on a firm, even surface.
• Insert the mains adapter connector into the mains adapter
socket on the rear of the device.
• Insert the mains adapter into a suitable socket. The time
is shown on the device display.
Note
• If you would like to reset the device to the factory set-
tings, press in the reset button on the underside of the
device using a pointed object.
6. Operation
Note
The device exits the settings menu automatically if no but-
ton is pressed for 10 seconds.
6.1 Setting the time and snooze duration
• Press the
button.
The time will start to flash.
Using the / buttons, select the desired time.
Note
To navigate through the hours or minutes more quickly,
press and hold the / button.
• Confirm the selected time with the
"24 Hr" now flashes on the display.
You can now choose between 12 and 24-hour format.
• Using the / buttons, select the desired hour format and
confirm with the
"Zz 05" now flashes on the display.
• Using the / buttons, select the desired snooze duration
(5-60 minutes) and confirm with the
Note
In order to read the time in the dark, press the cover of the
lamp (at the front) downwards.
6.2 Setting the alarm
You can set two separate alarm times (alarm 1 and alarm 2)
on the wake-up light.
• To set alarm 1, press the
• To set alarm 2, press the
The corresponding alarm time starts to flash on the display.
• Using the / buttons, set the desired alarm time.
• Using the
button, select your desired alarm sound
for this alarm time.
You can choose between radio ( ) and a beep (
• Confirm using the
17
button.
button.
button.
button once.
button twice.
button.
).