Baud Rate; Sound Signals; Use Of Remote Control Pedal - Chauvin Arnoux C.A 6121 Manual De Instrucciones

5.7.4. Baud rate

How to set the baud rate ?
1. Press the SET UP key and keep it pressed for approx. 2 s until the Baud menu is
displayed (see fig.39) :
2. Press the BAUD key to open the baud rate setup menu (see fig. 40)
3. Press the ñ and ò keys to set the rate to 300, 600, 1200, 2400, or 4800 bauds.
4. Press the EXIT key to return to the main menu.
5.8.

SOUND SIGNALS

There are 3 different types of sound signals :
a) Continuous signal : The displayed result is outside the set limit
b) Beep signal : Signals pressing of a key or turning of rotary switch
c) Beep-beep signal : End of the timer or of a recording, erasing, printout or transmission to a PC.
5.9. USING THE REMOTE CONTROL PEDAL
The remote control pedal is used to trigger and to stop the measurement (in each function), as well as to save the displayed result
with the foot. We recommend using the pedal when both hands are occupied with the test probes, or when tests are being made
at a distance from the instrument, by means of longer cables.
Fig.41. Connection of the remote control pedal to the C.A 6121 MACHINE TESTER
NOTE : When the remote control pedal is connected to the instrument, the START function on the front panel is not operational,
whilst the STOP function is operational.
How does the remote control pedal work ?
The START/STOP function of the pedal is absolutely identical to that of the front panel of the instrument when the pedal is not
connected.
The SAVE function of the pedal is automatic, which means that you simply press the SAVE pedal once to save the result
displayed in the location following the machine number. The machine number must be defined beforehand.
230V / 50Hz
500VA
REMOTE WARNING LAMP 12V~ RS232C
INSULATION (M ) W
DISCHARGE TIME ( t) D
500 - 1000 V
+
TEST
600V 600V 250V CAT III
ON
MAINS OFF
TEST
CONTINUITY 12V/>10A ( U,R D 10A ) TEST ON
MEM/MR PRINT/RS SET-UP
P2 C2
C1 P1
DIELECTRIC (HV)
CHAUVIN
C.A 6121
ARNOUX START / STOP
1 - 1.25 - 1.5 kV MACHINE TESTER
START/STOP
IDENT
3
2
GND
1
5
front view
2
Pedal switches
1
3
5
46
SOFTWARE VERSION
MT 1.00
BAUD : 4800
BAUD
Fig.39. Baud rate menu
SOFTWARE VERSION
MT 1.00
BAUD : 4800
Exit
Fig.40. Baud rate setup menu
Instrument connector
(female) type MAB 6100
DIN 45322 (front view)
4
SAVE