Peg-Perego Viaggio 2-3 Shuttle Instrucciones De Uso página 22

shoulder belt, located under the seat's
packaging (b).
How to attach the car seat
to the vehicle
if you own a car with
Isofix attachments
This type of attachment can be used
if your car is fitted with Isofix hooks.
Otherwise, go to the next section. For
further information on the availability of
these hooks and their location, refer to
the vehicle's instruction manual.
Fastening the
guarantees greater stability and
safety in the vehicle, but cannot
replace the restraining function of
the vehicle's seat belts.
3• To lengthen the connectors inside of
the seat, turn the handle on the front
of the seat, placing your hand into the
slot shown in yellow (fig_a) pulling it
longitudinally towards you (fig_b).
The connectors will automatically be
expelled (fig_c). Repeat to ensure that
the connectors have been expelled at
the same time and are extended fully.
4• Fix the connectors of the car seat to
the Isofix hooks in the car itself, verifying
that they "click" into place.
5•
IMPORTANT: The vehicle's Isofix
hooks and the seat are correct coupled
when a green signal appears above the
connectors (fig_a). A red signal indicates
that the attachments have NOT been
coupled correctly (fig_b).
6• Once the seat is correctly hooked,
pull the central handle again (fig_a) and
simultaneously push it against the seat
(fig_b).
7• To release Viaggio 2-3 Shuttle from
the seat, pull the handle (1) until the
connectors are completely exposed. By
doing this, the yellow release buttons
will be visible on the sides of the base;
pull the two buttons (2) until you hear
the click of the connectors opening.
You can the proceed to remove the seat.
8• To reposition the connectors within
the seat, pull the lever (1) while pushing
one of the two connectors (2) until they
are barely visible.
attachments
How to attach the car seat
to the vehicle
if you own a car with no
Isofix attachments
9• Place the Viaggio 2-3 Shuttle on
the vehicle seat in the direction of
travel, leaving the connectors within
the seat.
How to secure your child
with Viaggio 2-3 Shuttle
10• Strap the child in as in the figure,
ensuring that the seat does not move
during this operation.
11• Secure your child with the vehicle
seat belt as shown in the figure.
12• Fasten the seat belt, ensuring that it
clicks into place. Position the two parts
of the seat belt as shown in figure; both
the waist and shoulder straps must pass
under the armrest.
13• To complete the installation process
into the car, the adjustable shoulder
22