IKRA RT 1003 DA Instrucciones De Manejo página 12

1) Instructions regarding to safe handling
a) Wear goggles or properly fitted safety glasses,
sturdy closed shoes with non-slip soles, gloves,
snug-fitting work clothes and ear protectors (ear
plugs or ear mufflers).
b) Minors should never be allowed to use an electric
trimmer. Never lend or rent your electric trimmer
without these operating instructions.
c) Do not use the trimmer if other persons, above all
children, or animals are near the working area.
d) Work calmly and stay alert. Operate the trimmer
under good visibility and daylight conditions only.
e) Before using the machine, the line and extension
cords have to be checked for signs of damage or
ageing. Do not use the trimmer when the cords
are damaged or worn.
f) Do not use damaged power supply cords, extension
cords, couplings, plugs or cutting heads.
g) Careless use can cause injuries to hand and feet
by the rotating cutting elements. Do not switch on
the unit when hands or feet are near the cutting
elements.
h) Warning ! Danger of injury by the line cutting
device. After replacing a spool or lengthening the
cutting line, be sure to bring the unit onto normal
working position before turning it on again.
i) Never use metal cutting devices.
j) Only use original spare parts.
k) Always switch off the trimmer and disconnect the plug
from the power supply before carrying out any main-
tenance or repair work on the unit.The device must
always be switched off and the plug removed from the
socket before all adjustments or cleaning, or before the
connection is checked for creases or damage.
l) Inspect cooling air slots on the motor housing at
regular intervals for clog-ups and clean as necessary.
2) Maintenance
a) Always switch off your trimmer and disconnect it
from the power supply before taking a break and af-
ter finishing work. Do not forget maintenance. (Plug
disconnected!) Only carry out maintenance and
repairs described in these operating instructions.
b) Children should be under supervision to ensure
that they do not play with the device.
c) Any other work should be performed by your dealer.
d) Never use metal cutting devices.
e) Clean the cutting head at regular intervals.
f) Check the condition of the cutting head at frequent
intervals. If the behaviour of the cutting head chang-
es (vibration, noise), check immediately as follows:
Switch off the trimmer, hold it firmly and bring the
cutting head to a standstill by pressing it against the
ground. Then disconnect plug from power supply.
Check condition of cutting head - look for cracks.
g) Have a damaged cutting head replaced imme-
diately - even if it only has superficial cracks.
Never attempt to repair a damaged cutting head.
h) Inspect cooling air slots on the motor housing at
regular intervals for clog-ups and clean as necessary.
i) Clean plastic parts with a damp cloth. Do not use
Operating Instructions | GB
aggressive cleaning chemicals.
j) Never hose down the electric trimmer!
k) Store trimmer indoors in a dry, high or locked
place and always keep out of reach of children.
3) General Instructions
1. Read the instructions manual
2. Have your dealer or a specialist show you how to operate
your trimmer.
3. Before using the machine, the line and extension cords
have to be checked for signs of damage or ageing. Do not
use the trimmer when the cords are damaged or worn.
4. If the cord is damaged during utilisation, it must be discon-
nected immediately from the mains. DO NOT TOUCH
THE CORD BEFORE IT IS DISCONNECTED FROM
THE MAINS.
5. Do not use damaged power supply cords, extension
cords, couplings, plugs or cutting heads.
6. Attention! Danger. The cutting head continues to rotate
after switch-off (flywheel effect). Keep your fingers and
feet well clear to avoid injury.
7. Hold the extension cord so that it is always away from
the rotating nylon line.
8. For a safe operation, it is recommended to supply the
machine over a fault current safety breaker (RCD)
with a fault current not over 30 mA. Contact an elec-
trician for further information.
9. Before starting work check that your electric trimmer
is in good condition and that it is operating properly.
Pay special attention to the power supply cord, exten-
sion cord, power outlet, switch and cutting head.
10. Attention: The mains connection line of this device
must be replaced by the manufacturer's technical
service personnel or a qualified electrician only!
11. Only use extension cords that are approved for outdoor
use and that are not lighter than rubber tube cords type
H07 RN-F according to DIN/VDE 0282 with a diam-
eter of at least 1.5 mm
splashwater-proof. Never operate your trimmer without
a properly mounted and secured safety cover. Check
tightness of cutting head.
12. Never tug the extension cord to disconnect the plug.
Always grip the plug.
13. Arrange the extension cord so that it cannot be dam-
aged and does not cause a hindrance.
14. Be careful not to chafe the extension cord on cor-ners,
pointed or sharp objects. Do not squeeze extension
cord, e.g. through narrow gaps in doors or windows.
15. Transporting the electric trimmer, e.g. carrying it to
another site: Switch of the unit, disconnect the plug.
4) Operational Precautions
1. Make sure the open side of the protection guard is point-
ing away from yourself before you switch on the trimmer.
2. Wear goggles or properly fitted safety glasses, sturdy
closed shoes with non-slip soles, gloves, snug-fitting work
clothes and ear protectors (ear plugs or ear mufflers).
3. Always hold your trimmer firmly - make sure you
always maintain a good balance and secure footing.
4. Use particular caution while working in dense growth
areas where your view of the ground is obscured.
5. Never leave your trimmer outdoors in rain.
. Couplings and plugs must be
2
GB-2