IKRA RT 1003 DA Instrucciones De Manejo página 14

at least 2.5 cm (1 inch) long. If the lines are shorter: Switch off
the trimmer, disconnect plug from power supply. Press in the
spool and pull end of lines firmly outwards (fig. 7). If end of lines
are not visible - see point 11 (replacement of spool).
Your trimmer has a thread cutting blade that continuously
cuts the thread down to the appropriate length (fig. 8).
Note: Clean the thread cutting blade from grass remain-
ders in order to guarantee an unaffected cutting perform-
ance.
Attention: Danger of injury through the cutting blade !
11. Replacement of spool
First, switch off and unplug the device. Wait until the nylon
thread has come to a halt. T hen push the two locking
devices 1 at the sides of the cutting head, and remove the
cutting head cover 2 (fig. 9). Remove the used thread coil
and put in the new coil 3 such, that one end of the thread
comes out of each outlet at the sides of the cutting head
(fig. 10). Please take care that the spring 4 is properly
seated under the thread coil. Finally, close the cover by
pushing it in its seat. Both locks must properly engage.
12. Trouble shooting
• Trimmer does not work: Check power supply (e.g. by
testing on another socket or by means of a voltage tester).
Should it still not work, although the socket is o.k., send it
undismantled to an authorised service station for repair.
• Cutting line disappears into spool: Remove spool
(acc. to point 11), pull end of line through the metal
outlet and reinsert spool. In case nylon line is used up
insert a new spool with line.
Do not make any other repairs on your own; have your
trimmer checked and repaired by an authorised dealer.
13. Storing
• Clean the unit thoroughly, especially the cooling air slots
on the motor housing.
• Do not use water to clean the device.
• Store trimmer indoors in a dry, high or locked place
and keep out of reach of children.
14. Repair saervice
Repairs to electric power tools should only be carried out
by a specialised electrician.
15. Waste disposal and environmental protection
If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but
dispose of it in an environmentally friendly manner.
Please dispose of the device itself at an according collect-
ing/recycling point. By doing so, plastic and metal parts
can be separated and recycled. Information concerning the
disposal of materials and devices are available from your
local administration.
Operating Instructions | GB
16. Spare parts
Replacement spool
Protection cover
17. Warranty
For this electric tool, the company provides the end user -
independently from the retailer's obligations resulting from
the purchasing contract - with the following warranties:
The warranty period is 24 months beginning from the
hand-over of the device which has to be proved by
the original purchasing document. For commercial use
and use for rent, the warranty period is reduced to 12
months. Wearing parts and defects caused by the use
of not fitting accessories, repair with parts that are no
original parts of the manufacturer, use of force, strokes
and breaking as well as mischievous overloading of the
motor are excluded from this warranty. Warranty replace-
ment does only include defective parts, not complete
devices. Warranty repair shall exclusively be carried
out by authorized service partners or by the company's
customer service. In the case of any intervention of not
authorized personnel, the warranty will be held void.
All postage or delivery costs as well as any other subse-
quent expenses will be borne by the customer.
Art.-Nr. 13005000
Art.-Nr. 11020027
GB-4