Functional Description; Tool Assembly - Milwaukee V28 0730-20 Manual Del Operador

FUNCTIONAL DESCRIPTION

2
1
1. Front handle
2. Lock-off button
3. Trigger
4. Handle
5. Battery pack release buttons
6. Battery pack
7. Shoe
8. Lower guard lever
9. Lower guard
10. Blade bolt
11. Blade fl ange
12. Blade
12
18
13. Wrench
14. Bevel pointer
15. Bevel adjusting knob
16. Bevel scale
17. Rip fence adjusting knob
18. Depth adjusting lever
19. Upper guard
20. Rip fence slot
21. Sight line
22. Spindle lock button
3
4
5
7
8
9
11
10
13
15
14
16
17
19
22
6
Charge only V28™ Lithium-Ion battery
packs on V28 Lithium-Ion chargers.
Other brands of batteries may cause
personal injury or damage.
For specifi c charging instructions,
please read the operator's manual
supplied with your charger.
Fig. 1
6
Inserting a
battery pack
Removing Battery Pack from Tool
Push in the release buttons and pull the
battery pack away from the tool.
Inserting Battery Pack into Tool
To insert the battery pack onto the tool, slide
the pack onto the body of the tool. Make sure
it latches securely into place.
To reduce the risk of injury, always
remove battery pack before chang-
ing or removing accessories. Only
use accessories specifi cally recom-
mended for this tool. Others may be
hazardous.
Selecting Blade
Always use sharp blades. Dull blades tend
to overload the tool and increase the chance
of KICKBACK (see "Causes and Operator
20
Prevention of KICKBACK"). Only use thin
kerf blades with a maximum safe operating
speed greater than the no load RPM marked
on the tool's nameplate. Read the blade
manufacturer's instructions before use. Do
not use any type of abrasive cut-off wheel
21
or dry diamond cutting blades.

TOOL ASSEMBLY

WARNING
Installing and Removing Blades
1. REMOVE BATTERY PACK BEFORE IN-
STALLING OR REMOVING BLADES.
2. Place the saw on a fl at surface with the
blade facing upwards. To remove the
bolt from the spindle, push in the spindle
lock button. While holding in the spindle
lock button, use the wrench provided
with the tool to turn the bolt clockwise
(Fig. 2). Remove the bolt and blade
fl ange.
Fig. 2
Removing a
battery pack
3. Slide the lower guard lever up to raise
the lower guard. Remove the blade from
the spindle. Always clean the spindle,
upper guard and lower guard to remove
any dirt and sawdust.
NOTE: Do not remove inner blade
fl ange. Larger diameter of inner fl ange
(Fig. 3) should face the blade.
Spindle
WARNING Fig. 3
Inner fl ange
7
Bolt
Outer fl ange