Mowing; Adjusting Nylon Line; Line Feed On Autocut Mowing Head; Line Feed On Supercut Mowing Head - Stihl FSA 90 Manual De Instrucciones

English
► Turn the set wheel (1) to the required position.

12.3 Mowing

The cutting height is determined by the distance of the
cutting attachment from the ground.
► Swing the trimmer back and forth in an arc (A).
► If you are using a metal cutting attachment: Mow with the
left-hand side on the metal cutting attachment (B).
► Walk slowly and steadily forwards.

12.4 Adjusting Nylon Line

12.4.1 Line Feed on AutoCut Mowing Head

► Tap the rotating mowing head on the ground.
About 30 mm of fresh nylon line is advanced. The line
limiting blade in the deflector trims the mowing lines to the
correct length.
2 1
60
A
Automatic feed will not take place if the mowing lines are
shorter than 25 mm.
► Switch off the trimmer, push retaining latch to position
and remove the battery.
► Depress the spool (1) on the mowing head and hold it
depressed.
► Pull out the mowing lines (2).
B
► If the mowing lines (2) cannot be pulled out to the required
length: Replace the spool (1) or the mowing lines (2).
The spool is empty.

12.4.2 Line Feed on SuperCut Mowing Head

Mowing lines are advanced automatically. The line limiting
blade in the deflector trims the mowing lines to the correct
length.
Automatic feed will not take place if the mowing lines are
shorter than 40 mm.
► Switch off the trimmer, push retaining latch to position
and remove the battery.
► Pull out the mowing lines.
► If the mowing lines cannot be pulled out to required length:
Replace nylon line.
The spool is empty.

13 After Finishing Work

13.1 After Finishing Work
► Switch off the trimmer, push retaining latch to position
and remove the battery.
► If the trimmer is wet: Allow the trimmer to dry.
► If the battery is wet: Allow the battery to dry.
► Clean the trimmer.
► Clean the deflector.
► Clean the cutting attachment.
► Clean the battery.
13 After Finishing Work
0458-709-9821-B