INSTALLATION
INSTRUCTIONS
13
Unpacking
and Removing
Shipping
Bolts
When removing
the washer from the carton base, be
sure to remove the foam drum support
in the middle of
the carton base.
If you must lay the washer down to remove the base
packaging materials,
always lay it carefully
on its side.
Do not lay the washer on its front or back.
1
Remove the bottom two shipping
bolts with the
wrench (included).
Fully loosen all four shipping
bolts by turning
them counterclockwise,
and then
pull them out.
Shipping
_[
/
i
boltt
....
i,.L
/
J
2 Locate the four hole caps included
in the accessory
pack and install them in the shipping
bolt holes.
Foam
Drum
Carton
Base
Support
--@ NOTE
--
o Save the bolt assemblies
for future use. To prevent
damage to internal components,
do not transport
the washer without
reinstalling
the shipping
bolts.
o Failure to remove shipping
bolts and retainers
may cause severe vibration
and noise, which can
lead to permanent
damage to the washer. The
cord is secured to the back of the washer with
a shipping
bolt to help prevent operation with
shipping
bolts in place.
\ ....................................................................................................................................................................................
J