Product may vary slightly from what is illustrated.
13
12
11
10
1. Food pusher (Part # D905801930007879)
2. Food fingers
3. Food chute
4. Cover (Part # D90581019200)
5. Tab
6. Slice and shredder disk (Part # D905810220007878)
7. Chopping blade (Part # CN90580102)
8. Hi and Lo speed control
9. Off/Pulse control
10. Center post
11. Base
12. 8-Cup (1892 ml) container (Part # D90580079200)
13. Disk stem (Part # D905801020007878)
4
1
2
3
4
5
6
7
8
9
How to Use
This product is for household use only.
• Before first use, unpack the product and remove packing material. Handle
sharp chopping blade and slice and shredder disk carefully.
• Please go to www.prodprotect.com/applica to register your warranty.
• Remove and save literature.
• Wash all parts except base.
Note: do not attempt to chop ice in this food processor; it will damage container
and dull chopping blade. This unit will not whip cream, beat egg whites to
a desirable volume, grind coffee beans or spices with a high oil content, or slice
or shred hard-cooked eggs, marshmallows, or soft cheeses.
CONTROLS
HI or LO — When these buttons are pressed, unit runs continuously until oFF
button is pressed.
OFF — Processor should always be left in oFF position when unit is not in use.
PULSE — PUlSe position must be pressed and held for unit to operate. When
released, unit will stop. Use PUlSe for short processing tasks, such as
chopping nuts, raw meats, or vegetables. This lets you check processed results
and control the fineness.
Important: For your protection, this unit has an Interlock system. The
processor won't operate unless container is properly locked onto base
(see illustration on the base). The tab on cover must be correctly
locked into the slot on base. Be sure cover is turned fully into slot
toward LOCK/
until you hear it click into place. Do not attempt to
operate unit without container and cover correctly locked in place.
Be sure base is on a flat, dry, clean surface before you begin
processing.
TO SLICE OR SHRED
1. Place container over center post in base with handle at
left. Turn container towards base until it drops down into
place. Snap container in towards base and be sure the
locking tab locks into place (A).
A
2. To process directly into included container, place the disk
stem onto the center post in the container, then grasp the
slice and shredder disk by its hub with the (slice or shred)
up and push it down onto the disk stem (B).
3. Place food cover onto container so that its tab is facing
down towards base. Twist food cover in toward base to
loCK/
until you hear it click into place.
B
4.
Plug cord into an electrical outlet.
5