How To Use - BLACK&DECKER MiniPro MFP200T Instrucciones De Uso

MFP200T 1/18/07 8:03 AM Page 4
Product may vary slightly from what is illustrated.
† 1. Food pusher (Part# MFP200T-01)
† 2. Cover with continuous flow chute (Part# MFP200T-02)
† 3. Slice/shred disc with hub (Part# MFP200T-03)
† 4. Discharge disc (Part# MFP200T-04)
† 5. Chopping lid (Part# MFP200T-05)
† 6. Chopping blade (Part# MFP200T-06)
† 7. 2-Cup (480 ml) Bowl (Part# MFP200T-07)
8. Post
9. Base
10. High/Low/Off/Pulse Control
†Consumer replaceable/removable parts
3

How to Use

This product is for household use only.
• Before first use, unpack the product and remove packing material. Handle sharp
chopping blade and slice/shred discs carefully.
• Wash all parts except base.
Note: Do not attempt to chop ice in this food processor; it will damage container and dull
chopping blade. This unit will not whip cream, beat egg whites to a desirable volume,
grind coffee beans or spices with a high oil content, or slice or shred hard-cooked eggs,
marshmallows, or soft cheeses.
CONTROLS
OFF — Processor should always be left in OFF position when unit is not in use.
PULSE — PULSE button must be pressed and held for unit to operate. When released, unit
will stop. Use PULSE for short processing tasks, such as chopping nuts, raw meats, or
vegetables. This lets you check processed results and control the fineness.
Using the Food Processor
IMPORTANT: For your protection this unit has an interlock
system. When you slip the bowl over the post, turn it toward
the base so that it locks into place. Be sure to turn the cover
(or chopping lid, depending on use) toward the lock position so
that the Tab locks into the slot on the Base (A). This unit will
not operate unless the cover (or chopping lid) is locked into
place.
A
How to slice or shred
1. Slip the bowl over the center post and twist it toward the base so that the bowl locks
into place.
2. Carefully grasp the slice/shred disc by the hub or its edges with the desired side (slice or
shred) up, and push it down onto the top of the discharge disc. Slip the discharge disc
(with slice/shred disc) over the center post.
3. Place the cover with continuous flow chute onto the bowl and twist it toward the base
( ) until you hear it click into place (A). Position a large, low serving/preparation
LOCK
bowl under the continuous flow chute to catch food and spatter. Rimless bowls work
better than bowls with a lip.
4. Plug the cord into an electrical outlet.
5. Use the food guide to help you prepare food for slicing or
shredding. Fill the food chute and position the food pusher
over the food.
6. Push down with a light but steady pressure on the food
pusher while pressing the desired speed: Hi, Low (B). Press
and hold the pulse position for short processing tasks, such
as slicing a cucumber. The unit will stop when you release
the pulse button. Use the Hi, Low, position for continuous,
longer processing tasks, such as shredding cabbage
B
or carrots.
NOTE: Let the processor do the work. Heavy pressure will not speed up operation. Do not
use the processor continuously for more than 3 minutes at a time. Occasionally turn the
serving bowl during processing to prevent food build up in the continuous flow chute that
could fall out of the bowl. Be sure the processor and bowl are far enough back on the
counter to prevent bits from falling on the floor.
4