Battery Installation; Emergency Braking; Brush/Pad Installation And Uninstallation - Viper AS530R Manual De Usuario

Ocultar thumbs Ver también para AS530R:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USER MANUAL
4. Unscrew the screw (B, Figure 4) on control panel, then turn over the PCBA (A) on the panel to find DIP switch (D),
follow Figure 4 for DIP settings.
5. Perform steps in reserve order of disassembly to fix control panel and lock the screw after setting is done.
WET BATTERIES
(NOTE: Turn pin1 and pin2 of DIP switch
1
to "OFF")
DISCOVER EV AGM BATTERIES
(NOTE: Turn pin 1 of DIP switch to "ON",
2
pin2 to "OFF")
GENERAL GEL/AFM BATTERIES
(NOTE: Turn pin1 and pin2 of DIP switch
3
to "ON")

Battery Installation

6. Open the recovery tank cover (4) and check the recovery tank (3) is empty, otherwise, empty it with the drain hose
(15).
7. Close the recovery tank cover (4).
8. Overturn the recovery tank (3) carefully.
9. The machine is supplied with cables suitable to install 2X12V
batteries. Carefully put the batteries into the compartment,
then install them correctly.
10. Route and install the battery cable as shown in (Figure 3),
then carefully tighten the nut on each battery terminal.
11. Place the protection cap on each terminal, then connect the
battery connector.
12. Carefully lower the recovery tank (3).
Charging the Batteries
13. Charging the batteries. [Refer to MAINTENANCE chapters].

EMERGENCY BRAKING

If there is any emergency during machine operating, press the emergency switch (A, Figure 5), then all functions of
machine will stop, there is no display on control panel (B, Figure 5)

BRUSH/PAD INSTALLATION AND UNINSTALLATION

NOTE
Install suitable brush (A, Figure 6) or Pad (B and
C, Figure 6) according to the type of floor to be
cleaned.
CAUTION
Before installation or uninstallation of brush or
pad, make sure all the switches on machine are
in off position and lifting up the squeegee from
the floor. The operator must be equipped with
suitable personnel protection devices such as
gloves to reduce the risk of accidents. Proceed as
following:
Figure 4
Figure 5
Figure 6
10
D
C
A
C
ENGLISH
A
B
B
A
B

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

50000417

Tabla de contenido