Accessories; Standard Accessories - Hitachi M8V2 Manual De Instrucciones

WARNING:
NOTE:
Accessories are subject to change without any obligation on the part of the HITACHI.

STANDARD ACCESSORIES

(1) Bar Holder (Code No. 325-217) ......................................................................................... 1
Straight Guide (Code No. 956-797) .................................................................................. 1
Feed Screw (Code No. 956-793) ....................................................................................... 1
Wing Bolt (Code No. 949-394) .......................................................................................... 1
(2) Guide Bar (Code No. 325-216) .......................................................................................... 2
(3) Wing Bolt (Code No. 301-806) .......................................................................................... 4
(4) 23 mm Wrench (Code No. 323-295) ................................................................................. 1
(5) Template Guide (Code No. 956-790) ................................................................................ 1

ACCESSORIES

ALWAYS use Only authorized HITACHI replacement parts and
accessories. NEVER use replacement parts or accessories which are
not intended for use with this tool. Contact HITACHI if you are not sure
whether it is safe to use a particular replacement part or accessory
with your tool. The use of any other attachment or accessory can be
dangerous and could cause injury or mechanical damage.
English
17