Preparing The Remote Controller - DJI AGRAS T16 Guia De Inicio Rapido

3. Preparing the Remote Controller

Charging the Battery
Press the battery level button once to check the battery level. Fully charge the batteries before using for the
first time.
Place the battery into the charging
hub, connect the AC power adapter
to the charging hub, and connect the
AC power adapter to a power outlet
(100-240 V, 50/60 Hz).
Mounting the Battery
The remote controller uses an easily removable,
interchangeable Intelligent Battery for long-term operation.
Slide the battery compartment cover lock on the back of
1
the remote controller down to open the cover.
Insert the Intelligent Battery into the compartment and
2
push it to the top.
Close the cover.
3
To remove the Intelligent Battery, open the cover, press
●
and hold the battery release button, then push the
battery downward.
Mounting the Dongle and SIM Card
Only use a DJI-approved dongle.
●
The dongle supports various network standards. Use a SIM card that is compatible with the chosen
●
mobile network provider, and select a mobile data plan according to the planned level of usage.
The dongle and SIM card enable the remote controller access to specific networks and platforms, such
●
as the DJI AG platform. Make sure to employ them correctly. Otherwise, network access will not be
available.
Dongle
* Test procedure: Press the remote controller power button once, then press again and hold to power the remote
controller on. In the DJI MG2 app, tap
the network chain are shown in green, the dongle and SIM card are functioning properly.
6
Charging Hub
Lift the dongle compartment cover at the gap at its lower right
corner, then remove it.
Insert the dongle into the USB port with the SIM card inserted
into the dongle and test it.*
Reattach the cover. To secure the cover, open the silicone
protectors, insert and tighten two Phillips screws, and close the
protectors.
, then and select Network Diagnostics. If the status of all the devices in
Power Outlet
AC Power Adapter
3
Battery Release
2
Button