More Functions - DJI AGRAS T16 Guia De Inicio Rapido

Performing an Operation
Take the aircraft
to one of the
calibration points.
Tap Rectify Offset.
Only take off in open areas, and set an appropriate auto-takeoff height according to the operating
●
environment.
An operation can be paused by toggling the Pause switch. The aircraft will hover and record the
●
breakpoint, and then the aircraft can be controlled manually. To continue the operation, select it again
from the Executing tag in
the operation. Pay attention to aircraft safety when returning to the breakpoint.
In Route Operation mode, the aircraft is able to circumvent obstacles, which is disabled by default and
●
can be enabled in the app. If the function is enabled and the aircraft detects obstacles, the aircraft will
slow down and circumvent the obstacles, and then return to the original flight path.
The aircraft will hover at the endpoint of the flight route after the operation is completed. Instead of
●
hovering, the aircraft can also be set to perform other actions in the app.
More Operation Modes
Refer to the user manual for more information about the A-B Route, Manual, and Manual Plus Operation
modes.

More Functions

Operation Resumption
Refer to the user manual for more information.
6. Maintenance
Clean all parts of the aircraft daily, immediately after spraying:
A. Completely fill the spray tank with clean water or soapy water and spray the water through the nozzle until
the tank is empty. Repeat the step two more times.
B. Detach the spray tank to clean it. Remove the spray tank strainer, nozzle strainers, and nozzles to clean
them and clear any blockage. Afterwards, immerse them in clean water for 12 hours.
C. Use a water-filled spray washer to clean the aircraft body and wipe it with a soft brush or wet cloth before
cleaning water stains with a dry cloth. DO NOT splash the aircraft body with an excessive volume of water.
Refer to the disclaimer and safety guidelines for more information on product maintenance.
10
Tap Execute Operation
in the home screen of
the app.
Tap Start.
list, and the aircraft will return to the breakpoint automatically and resume
System Data Protection
Tap , select
the field from
the field list, and
select Invoke.
Set the operation
parameters, then
confirm.
Empty Tank Warning
Adjust the flight route
parameters including route
angle, line spacing, and
collision avoidance safety
Set the auto-takeoff height
and move the slider to
take off. The aircraft will
perform the operation
automatically.