Checking The Battery Level - DJI AGRAS T16 Guia De Inicio Rapido

Checking the Battery Level

Adjusting the Antennas
Tilt the display device on the remote controller to the desired position, then adjust the antennas, so they are
facing outward. The strength of the remote controller signal is affected by the position of the antennas.
Strong
Optimal Transmission Zone
Avoid using wireless devices that use the same frequency bands as the remote controller.
●
4. Getting Ready for Takeoff
A. Place the aircraft on open, flat ground with the Aircraft Status Indicators facing toward you.
B. Make sure that the propellers are securely mounted, there are no foreign objects in or on the motors and
propellers, the propeller blades and arms are unfolded, and the arm sleeves are firmly tightened.
C. Make sure that the spray tank and flight battery are firmly in place.
D. Pour liquid into the spray tank, and tighten the cover. Make sure that the four lines on the cover are aligned
in the same position as in the figure below.
E. Power on the remote controller, make sure that
the DJI MG2 app is open, and then power on the
aircraft.
When using for the first time, activate the aircraft
●
using the DJI MG2 app. Your DJI account and an
internet connection are required.
Internet
Low
Weak Unfold
Try to keep the aircraft inside the optimal transmission zone. If the signal is
weak, adjust the antennas or fly the aircraft closer.
High
Press once to check the battery level.
Press once, then press again and hold for
two seconds to power on or off.
7