Surtek CB632 Manual De Usuario Y Garantía página 8

Firing the nails:
Hold the nailer in place. Make sure that the safety
mechanism is fully depressed, and pull the trigger
to fire the nail, release the
trigger and repeat until the
job is done.
Adjusting the driving depth:
To adjust the penetration depth of the nail into the
work-piece:
Turn the depth adjustment knob (2) clockwise (+)
to increase the depth of penetration, and counter
clockwise (-) to decrease the depth of penetration.
NOTE: It is advisable to practise on a scrap
piece of wood of the same type te correctly set the
penetratian depth.
Unblocking jammed fasteners (nails):
In the unlikely event that nails become jammed,
follow these instructions to remove them.
Caution: Always remove the battery pack
before carrying out any type of maintenance.
1. Remove the plastic protection cover (picture 1).
2. Remove the plate retaining bolts (picture 2).
Caution: Note the location as well as the
order in which parts are removed from the nailer,
this will make it easier to rebuild it.
3. Remove the safety rnechanism retaining plate
(picture 3).
4. Remove the firing pin retaining plate (picture 4).
8
Picture 1
Picture 2
Safety mechanism shaft
Picture 3
Picture 5
Plastic
Protection
Cover
Plate
retaining
bolts
Picture 4
5. Loosen the
depth control
knob. This will
allow the firing
pín to move
more easily, and
make removing
the offending
nails more simple
(picture 5).