Before Returning For Repairs; Specifications; Replacement Parts - Schumacher Electric BE01258 Manual Del Usuario

PROBLEM
The unit won't jump start my car.
The unit won't power my 12V or USB device.
The display shows JUMP START READY-BATTERY
COLD REDUCED PERFORMANCE.
Beeping sound and display shows
BATTERY LOW-RECHARGE.
The green LED is flashing and the display shows
CHARGE ABORTED-SEE MANUAL.

13. BEFORE RETURNING FOR REPAIRS

For information about troubleshooting, contact customer service for assistance:
services@schumacherelectric.com | www.batterychargers.com | or call 1-800-621-5485
For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485. DO NOT SHIP UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION (RMA)
number from Customer Service at Schumacher Electric Corporation.

14. SPECIFICATIONS

Internal battery type ............................................................................ Lithium Iron Phosphate (Lithium Ion)
Chargers ..........................................................................................................100V~120V AC wall charger
Capacity ...................................................................................................................... 12,000 mAh/38.4 Wh
12V DC power output ...............................................................................................................................6A
USB output .................................................................................................................................. 5V DC, 2A
Jump start ............................................................................................................ 400A peak/270A cranking
Light ..............................................................................................................................................1W/90 Lm
Overload protection ................................................................................................................................ Yes

15. REPLACEMENT PARTS

USB/Micro USB adaptor 991240 ............................................................................................3899003378Z
Battery clamp adaptor 991200 ................................................................................................3899003375Z
12V DC car charger 991220 ...................................................................................................2299002681Z
AC wall charger 991210 .............................................................................................................93026943Z
12V DC port adaptor 991230 ..................................................................................................3899003396Z
Case 991250 .......................................................................................................................... 5899000011Z
POSSIBLE CAUSE
Clamps are not making a good connection to the
battery.
The internal battery is not charged.
The temperature of the internal battery is above
131°F (55°C).
The vehicle's battery voltage is over 15V.
The vehicle's battery voltage is below 1V.
The outside temperature is less than 14°F (-10°C).
The vehicle's battery is defective.
The device is not turned on.
The internal battery is not charged.
The temperature of the jump starter's internal battery
is too low.
The internal battery was discharged, when using the
12V/USB function.
The internal battery was discharged, when using the
jump starter.
Charging has aborted. The battery is not accepting
a charge.
12V DC car charger
• 7 •
SOLUTION
Check for poor connection to battery and frame.
Make sure connection points are clean.
Check the battery charge status and recharge, if
necessary.
Place the unit in a well-ventilated area, to cool the
battery.
You cannot use this jump starter for this vehicle.
Press and hold jump start button for 5 seconds, until
display shows JUMP START READY.
Try starting several times. If not successful, place the
unit in a warmer area for a short time.
Have the battery checked.
Turn on the device.
Check the battery charge status and recharge, if
necessary.
Turn on the headlights or try to jump start a few
times, to warm up the internal battery of the jump
starter.
If battery is not recharged, 12V/USB will shut off after
10 minutes.
Recharge the internal battery.
Reset the charger by briefly unplugging the unit. If
problem persists, call customer service.