Bosch Sensixx B45L Instrucciones De Uso página 23

Problem
The iron does not
produce any steam.
The ironed garment
turns dark and/or sticks
to the soleplate.
The soleplate turns
brown.
The appliance makes a
pumping sound.
Loss of pressure during
ironing.
Water spots appear on
the garment during
ironing.
Water spots appear on
the garment during use
of the "PulseSteam"
function.
The hose gets hot
during use.
Water leakage from the
boiler.
The iron does not stop
steaming after placing it
on the pad (2).
If the above does not solve the problem, get in touch with the authorised technical service.
Possible causes
• The boiler is not switched on or the
water tank is empty.
• The steam regulation is set to the
minimum position.
• The selected temperature is too
high and has damaged the
garment.
• This is a regular consequence of
usage.
• Water is being pumped into the
steam tank.
• Water tank (1) is not correctly
inserted in the housing.
• The sound will not stop.
• Steam release button activated
during a long period of time.
• May be caused by steam
condensed on the ironing board.
• Water spots are caused by steam
condensation in the hose when
cooling down after use.
• This is normal.It is caused by the
steam passing through the hose
during steam ironing.
• Filter (12*) located at the side of
the appliance is loose.
• "PulseSteam" function activated by
double click.
Solution
• Set the main power button (9) to the "I"
position (illuminated in red), and/or fill the
water tank.
• Increase the steam flow (see section C).
• Select a suitable temperature for the
material being ironed and clean the
soleplate with a damp cloth.
• Clean the soleplate with a damp cloth.
• This is normal.
• Adjust the water tank correctly.
• If the sound will not stop, do not use the
steam generator and contact an
authorised technical service centre.
• Use the steam release button at intervals.
This improves the ironing result as the
textiles will be dry and stay smooth better.
• Wipe the textile cover of the ironing
board, and iron the spots without steam to
dry them.
• Water drops stop coming out of the
soleplate after using the "PulseSteam"
function for some time.
• Place the hose on the opposite side so
that you cannot touch the hose during
ironing.
• Tighten up the filter.
• Just press the trigger once again and the
iron will stop steaming at once.
23
BOS CH