Settings; Initiating Setting Mode - Sony WRT-805B Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Settings

Initiating Setting Mode

In Setting mode, you can change the transmission channel
and the attenuation level, or reset the accumulated time
indication.
To enter Setting mode
While holding down the SET button, set the POWER switch
to ON.
Hold the SET button down until a display appears on the
liquid-crystal display.
The transmitter enters Setting mode and the indication
before the transmitter was previously turned OFF flashes on
the liquid-crystal display.
Each time you press the SET button, Group selection mode
(page 11), Channel selection mode (page 12), Attenuator
adjustment mode (page 13) and Accumulated time
indication reset mode (page 14) are cyclically switched.
Note
Group selection mode is valid only on the model available
in Europe, which permits you to select among from four sets
of the transmitting channels shown in "Sony Wireless
Microphone System Frequency List."
10
(GB)
Pressing the SET button switches the mode in the direction of ,.
Group
selection
CH
Accumu-
lated time
indication
CH
reset
Channel
selection
CH
Attenuator
adjustment
CH
Display example for CE62 model

Publicidad

Tabla de contenido
loading

Tabla de contenido