Power Supply - Sony WRT-805B Manual De Instrucciones

Power Supply

The transmitter can operate on one LR6 (size AA) alkaline
battery continuously for about 6 hours at 25°C (77°F).
Inserting the battery
1
Slide the lid in the direction of the arrow ( V ) to open the
battery compartment.
2
Match the polarities and insert the battery.
3
Close the lid and slide it in the reverse direction to lock.
Battery indication
When you turn the power on, the battery status appears in
the BATT indication on the liquid-crystal display.
Lid
1
BATT Lights Lights
indication
Battery Good Less than
condition half-charge exhausted
When the battery reaches stage 3 shown in the table, the
BATT indication on the WRR-805B/862B/WRU-806B also
starts flashing.
Promptly replace the battery when the indications flash.
Note
The indication may be incorrect if the battery is not new
when inserted. If you plan to use the transmitter for a long
period, it is best to replace the battery with new one.
Notes on battery
• Use a new alkaline battery.
• Be careful to insert the battery with the correct polarity.
• When not using the transmitter for a long period, remove
the battery to avoid leakage. If the battery does leak,
clean all leakage from the unit and insert a new battery.
Leakage left in the unit may cause poor battery contact. If
there seems to be poor battery contact, consult your Sony
dealer.
2 3 4
Flashes Goes off
Almost Completely
exhausted
7
(GB)