Warnings And Safety Instructions - Tanaka TPH-2501 Manual Del Propietário

2. Warnings and safety instructions

Operator safety
Always wear head protection with full face
shield to help protect against falling branches
and debris.
Avoid all power lines. This unit is not insulated
against electrical current.
Gloves should be used when sharpening
blades.
Always wear heavy, long pants, boots and
gloves. Do not wear loose clothing, jewelry,
short pants, sandals or go barefoot. Secure
hair so it is above shoulder length.
Do not operate this tool when you are tired, ill
or under the influence of alcohol, drugs or
medication.
Never let a child or inexperienced person
operate the machine.
Wear hearing protection.
Never start or run the engine inside a closed
room or building. Breathing exhaust fumes can
kill.
Keep handles free of oil and fuel.
Keep hands away from cutting equipment.
Do not grab or hold the unit by the cutting
equipment.
When the unit is turned off, make sure the
cutting attachment has stopped before the unit
is set down.
When operation is prolonged, take a break
from time to time so that you may avoid
possible whitefinger disease which is caused
by vibration.
The operator must obey the local regulations
of cutting area.
Unit / machine safety
Inspect the entire unit/machine before each
use. Replace damaged parts. Check for fuel
leaks and make sure all fasteners are in place
and securely tightened.
Replace parts that are cracked, chipped or
damaged in any way before using the
unit/machine.
Keep others away when making carburetor
adjustments.
Use only accessories as recommended for
this unit/machine by the manufacturer.
Never let the blade strike any obstacle.
If the blade makes contact, the machine
should be stopped and checked carefully.
All unit service, other than the items listed in
the operator's/owner's manual, should be
performed by competent machine service
personnel. (For example, if improper tools are
used to remove the flywheel or if an improper
tool is used to hold the flywheel in order to
remove the clutch, structural damage to the
flywheel could occur and could subsequently
cause the flywheel to burst.)
WARNING!
Never modify the unit/machine in any way.
Do not use your unit/machine for any job
except that for which it is intended.
Fuel safety
Mix and pour fuel outdoors and where there are
no sparks or flames.
Use a container approved for fuel.
Do not smoke or allow smoking near fuel or the
unit/machine or while using the unit/machine.
Wipe up all fuel spills before starting engine.
Move at least 3 m away from fueling site before
starting engine.
Stop engine before removing fuel cap.
Empty the fuel tank before storing the
unit/machine. It is recommended that the fuel
be emptied after each use. If fuel is left in the
tank, store so fuel will not leak.
Store unit/machine and fuel in area where fuel
vapors cannot reach sparks or open flames
from water heaters, electric motors or switches,
furnaces. etc.
WARNING!
Antivibration systems do not guarantee that
you will not sustain whitefinger disease or
carpal tunnel syndrome. Therefore, continual
and regular users should monitor closely the
condition of their hands and fingers. If any of
the above symptoms appear, seek medical
advice immediately.
Cutting safety
Do not cut any material other than leaves or
small brunches objects.
For respiratory protection, wear an aerosol
protection mask when cutting the leaves after
insecticide has been applied.
Keep others including children, animals,
bystanders and helpers outside the 15 m
hazard zone. Stop the engine immediately if
you are approached.
Hold the unit/machine firmly with both hands.
Keep firm footing and balance. Do not over-
reach.
Keep all parts of your body away from the
muffler and cutting attachment when the
engine is running.
Before pruning branches, the operator must
be accustomed to the pruning techniques of
the machine.
Be sure to pre-plan a safe exit from falling
objects.
While cutting, hold the machine firmly with
both hands with thumb firmly locked around
front handle, and stand with feet well balanced
and your body balanced.
Maintenance safety
Maintain the unit/machine according to
recommended procedures.
Disconnect the spark plug before performing
maintenance except for carburetor adjustments.
Keep others away when making carburetor
adjustments.
Use only genuine Tanaka replacement parts
as recommended by the manufacturer.
TPH-230S/TPH-270S
Transport and storage
Carry the unit/machine by hand with the
engine stopped and the muffler away from
your body.
Allow the engine to cool, empty the fuel tank,
and secure the unit/machine before storing or
transporting in a vehicle.
Empty the fuel tank before storing the
unit/machine, It is recommended that the fuel
be emptied after each use. If fuel is left in the
tank, store so fuel will not leak.
Store unit/machine out of the reach of
children.
Clean and maintenance the unit carefully and
store it in a dry place
Make sure engine switch is off when
transporting or storing.
When transporting in a vehicle, cover blade
with blade cover.
If situations occur which are not covered in this
manual, take care and use common sense.
Contact Tanaka dealer if you need assistance.
Pay special attention to statements preceded by
the following words:
WARNING!
Indicates a strong possibility of severe
personal injury or loss of life, if instructions
are not followed.
CAUTION!
Indicates a possibility of personal injury or
equipment damage, if instructions are not
followed.
NOTE!
Helpful information for correct function and
use.
CAUTION!
Do not disassemble the recoil starter. You may
get a possibility of personal injury with recoil
spring.
GB-5