Spa Light Assembly Using A Replacement Kit - Pentair Water LED IntelliBrite Guía De Instalación Y Del Usuario

6
Replacing the IntelliBrite
(see page 10 for Replacement Kit part numbers)
Always disconnect power to the spa light at the circuit breaker before
servicing the light. Failure to do so could result in death or serious injury
to installer, serviceman, spa users, or others due to electrical shock.
1. Switch off main electrical switch or circuit breaker, as well as the switch which operates the IntelliBrite
light itself.
2. Before starting be sure that you have a new lens gasket (P/N 79108500) and an IntelliBrite
ready to install.
WARNING - Replace the LED light assembly with the same type and wattage. Failure to replace the LED light
assembly with the same type will damage the LED light fixture and may cause an electrical hazard resulting in
death or serious injury to pool and spa users, installers, or others due to electrical shock, and may also cause
damage to property.
WARNING - Always install a new lens gasket (part number 79108500) whenever disassembling the IntelliBrite
ED light fixture. Failure to do so may permit water to leak into the assembly which could cause:
(a) an electrical hazard resulting in death or serious injury to pool users, installers, or others due to electrical shock,
or
(b) breakage of the lens, which likewise could result in serious injury to pool and spa users, installers, or bystanders,
or in damage to property.
3. REMOVING THE INTELLIBRITE
assembly from the niche. Place the assembly on the deck. Note: It is not necessary to drain down the spa.
F Pilot screw
WARNING - Be sure to keep the pilot screw from the IntelliBrite
and electrically grounds the housing securely to the mounting ring and wet niche. Failure to use the screw provided
could create an electrical hazard which could result in death or serious injury to pool and spa users, installers
or others due to electrical shock.
®
Spa LED Light Assembly using a Replacement Kit
D A N G E R !
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
® LED LIGHT: Remove the pilot screw at top of face ring, remove the light
® LED spa light assembly
®
LED underwater light. This screw mounts
®
underwater
®