Using An External Isolating Safety Transformer For Multiple Intellibrite; 12 Vac Lights - Pentair Water LED IntelliBrite Guía De Instalación Y Del Usuario

12. Install the IntelliBrite
four (4) feet of cord at the light fixture to coil around the light; see Figure 1 (page 3). The four (4) feet of cord around
the light allows the light to be serviced after the spa is filled with water.
13. Cut the cord at the Junction Box, leaving at least six (6) inches of cord to make connections.
14. Strip six (6) inches of the outer cord jacket to expose the three (3) insulated wires (be careful not to damage the
insulation on the three inner wires).
15. Connect all three (3) wires to the corresponding circuit wires in the Junction Box and secure the Junction Box cover
in place.
WARNING - Never operate the underwater light for more than 10 seconds unless it is totally submerged
in water. Without total submersion, the light assembly will get extremely hot and may result in serious
burns or in breakage of the lens. This may result in serious injury to pool users, installers, or bystanders, or
in damage to property.
16. Install the IntelliBrite
WARNING - Use only the special pilot screw provided with this underwater light. This screw mounts and
electrically grounds the housing securely to the mounting ring and wet niche. Failure to use the screw provided
could create an electrical hazard which could result in death or serious injury to pool users, installers or others
due to electrical shock.
17. Fill the spa until the light is completely submerged in the water. Before powering on the light, be sure the light is
completely submerged in the water. The light should never be powered on out of the water for more than 10 seconds.
18. Final check for proper light operation: Switch on the main switch or circuit breaker, as well as the switch which
operates the light. The light should illuminate when power is applied. If not recheck the installation steps starting
with Step 12.

Using an External Isolating Safety Transformer for Multiple IntelliBrite

When using multiple IntelliBrite
(2) IntelliBrite ® pool lights and one (1) IntelliBrite
total cable run between the transformer and light (see diagram below).
300 Watt
Transformer
If a longer cable run is necessary, it is recommended that separate 100 Watt transformers be used for each light with
no more than 200 feet of total cable run between the transformer and light (see diagram below).
100 Watt
Transformer
® light assembly into the niche: Feed cord through conduit to Junction Box, leaving at least
® light assembly into the niche. Tighten the special bronze pilot screw to secure in place.
®
12 VAC LED lights on a 300 Watt transformer, it is recommended that no more than two
® Spa light be used. It is also recommended not to exceed 100 feet of
J Box
12 Gauge
(minimum)
J Box
12 Gauge
(minimum)
100 ft.
200 ft.
9
®

12 VAC Lights