Replacing The Intellibrite Spa Light Fixture After Electrical Requirements Are Met; Replacing The Intellibrite - Pentair Water LED IntelliBrite Guía De Instalación Y Del Usuario

Replacing the IntelliBrite

Note: The IntelliBrite
fixture is a sealed light assembly
which is replaceable. The lens,
gasket and facering can be removed
from the sealed light assembly for
replacement. See page 9 for
replacement kit part numbers.
WARNING - Failure to bring the pool and spa's electrical system up to code requirements before
installing the underwater light will create an electrical hazard which could result in death or serious injury to
pool users, installers, or others due to electrical shock, and may also cause damage to property.
1. Switch off main electrical switch or circuit breaker, as well as the switch which operates the IntelliBrite
light itself.
2. To remove the spa light fixture from the spa. Remove the special bronze pilot screw at top of face ring. Remove
®
the IntelliBrite spa light fixture from the niche and place it on the deck (see page 6 for removal instructions).
WARNING - Be sure to keep the special pilot screw from this underwater light. This screw mounts and
electrically grounds the housing securely to the mounting ring and wet niche. Failure to use the screw provided
could create an electrical hazard which could result in death or serious injury to pool users, installers or others
due to electrical shock.
3. Remove Junction Box cover, disconnect the light fixture wires, and pull the cord through the conduit.
4. Feed the new light fixture cord through the conduit from the niche to the Junction Box. Note: Depending on the length
of the conduit, special tools may be required to pull the cord through the conduit.
5. Leave at least four (4) feet of cord to coil around the light fixture; see Figure 1 on page 2. This four (4) feet of cord
coiled around the light allows the light to be serviced after the spa is filled with water.
6. Cut the cord at the Junction Box, leaving at least size (6) inches of cord to make connections.
7. Strip six (6) inches of the outer cord jacket from the cord to expose the three (3) insulated wires – be careful not to
damage the insulation on the three inner wires.
8. Connect all three (3) wires to the corresponding circuit wires in the Junction Box (black wire to power, white wire to
common, and green wire to ground) and secure the Junction Box cover in place.
WARNING - Never operate this underwater light for more than ten (10) seconds unless it is totally
submerged in water. Without total submersion, the light assembly will get extremely hot, which may result
in serious burns or in breakage of the lens. This may result in serious injury to pool and spa users, installers,
or bystanders, or in damage to property.
9. Replace the IntelliBrite
WARNING - Use only the special pilot screw provided with this underwater light. This screw mounts and
electrically grounds the housing securely to the mounting ring and wet niche. Failure to use the screw
provided could create an electrical hazard which could result in death or serious injury to pool users,
installers or others due to electrical shock.
10. Fill the pool and/or spa until the IntelliBrite
light for more than ten (10) seconds. Switch on main switch or circuit breaker, as well as the switch which operates
the IntelliBrite ® spa light itself to verify that the light is operating correctly.
®
Spa Light fixture after electrical requirements are met
®
Spa Light
® spa light fixture into the niche and tighten the special pilot screw.
®
spa light fixture is completely submerged in water before operating the
IntelliBrite spa light fixture with lens,
gasket and facering attached
5
® underwater