Pentair Water LED IntelliBrite Guía De Instalación Y Del Usuario página 12

8
8. INSTALLING THE INTELLIBRITE
reassembly of the IntelliBrite
REASSEMBLED.
9. Install the new gasket onto the lens:
a) With the light housing resting on its base, place the lens then the gasket on top of the light housing.
b) Place the face ring on top of the gasket. Make sure that the lens and gasket are centered correctly on the light
housing.
c) Aligning the face ring and lens: Align the face ring and lens so that the letter "O" in the word "TOP" and the
small arrow above it) on the surface of the lens points to the pilot screw hole on the face ring.
d) Aligning the lens position with the LEDs: While looking through the front of the lens, slightly rotate the lens
until the vertical lines on the lens are in focus with the four (4) rows of LEDs below.
Align letter "O" in
the word "TOP"
on lens with pilot
screw hole on
face ring
Align vertical line
on lens with rows
of LEDs under
10. With the hook ends of the circular uni-tension wire clamp pointing down, spread the clamp and place it in the "U"
recesses of the locking levers. Be sure the hook ends of the wire clamp are located between the pair of locking levers
as shown below and that the clamp is properly engaged with all of the lock levers.
11. Place a cloth on the ground to protect the lens. Turn the light over so the lens is resting on the cloth. Tighten the
bolt and nut until the distance between the ends of the clamp equals ¼-in. or less.
Hook ends
Lock lever
(x4)
® LED LIGHT WITH NEW GASKET: Install a new gasket (P/N 79108500) during
®
LED light. A NEW LENS GASKET MUST BE USED EACH TIME THE LIGHT IS
lens
IntelliBrite
Spa light
assembly
Gasket
Lens
Uni-tension
wire clamp
Screw and
bolt
Face ring
Pilot screw
Pilot screw
1/4" or Less
Tighten nut and bolt about 90˚ from
Pilot Screw
the Pilot Screw between the lock levers.
Orientation of bolt
and wire clamp.
90 Degrees
Pilot Screw