Pentair Water LED IntelliBrite Guía De Instalación Y Del Usuario página 11

4. Using a number three (3) Phillips head screwdriver loosen the screw and remove uni-tension wire clamp from the
face ring.
5. Remove the face ring and wire clamp from the light housing and set aside for installation later.
Note: A 12 VAC 60 Hz (50 Hz where
applicable) external isolating safety
transformer is required for the 12 VAC
model IntelliBrite ®
page 9 for more information.
Loosen the Phillips screw to
remove wire clamp
6. With the light assembly resting on its base, carefully pry off the gasket to release the lens. Discard the gasket.
A NEW LENS GASKET (P/N 79108500) MUST BE USED EACH TIME THE SPA LED LIGHT IS REASSEMBLED.
7. Disconnect the IntelliBrite
IntelliBrite
Gasket and Lens
LED Spa light. See
® Spa LED light assembly cable from the junction box and discard the light assembly.
®
Spa LED Light assembly
Face Ring and uni-tension wire clamp
7