Listening In Fm Stereo; Setting Up Am And Fm Outside Of North America; Tuning In Stations; Buttons - Eton E5 Operación Manual

BASIC RADIO OPERATION
When listening to FM or shortwave, fully extend the telescopic antenna
(44). It need not be extended when listening to AM stations (the AM
antenna is located inside the E5).

LISTENING IN FM STEREO

FM stereo can be heard when using earphones/headphones (47) or
when routing the audio to a stereo amplification device from the
'LINE OUT' socket (43). To hear FM in stereo, press the 'ST/MONO'
button (8) while tuned to a FM station. Note that 'STEREO' appears
in the display (38) when the stereo mode is selected.

SETTING UP AM AND FM OUTSIDE OF NORTH AMERICA

The E-5 is factory set-up for use in North America. To use the
NOTE:
E5 in North America (U.S. or Canada), no changes are needed.
In North America, AM stations are spaced by 10 KHz and the AM
band extends from 520 kHz to 1710 kHz. In most other world areas,
they are spaced by 9 KHz and the band extends from 522-1710 kHz.
Follow these steps to select the 9 kHz AM spacing for outside of
North America:
1. Turn off the E-5.
2. Press the F5 button for about 3 seconds, or until '9' or '10' flashes
in the display.
3. Release the button and give it a quick, short press to toggle to the
other setting.
4. When finished, press the 'PAGE/TIME' button (4) twice.
16
continued
BASIC RADIO OPERATION
In North America, the FM band extends from 87.5-108 mHz. In other
parts of the world, it may extend from 87-108.1 or from 76-108.1. To
select the correct range for your region follow these steps:
1. Turn off the E5.
2. Press the F5 button for about 3 seconds, or until '9' or '10'
flashes in the display.
3. Release the button and give the PAGE/TIME button (4) a quick,
short press.
4. Sequentially press the F5 button until the beginning FM
frequency of your area appears.
5. Give the PAGE/TIME button (4) a quick, short press.

TUNING IN STATIONS

Described below are four methods of tuning-in stations:
(6), Tuning-Knob (40), Direct Frequency Entry (9) and Auto-Scan (6).

BUTTONS (6)

Quick, short, sequential presses of the
or down frequency (33)(34)(35). All normal tuning for AM, FM and
shortwave stations can be performed with the
steps used are 9 or 10 kHz in the AM band, 5 kHz in the shortwave
bands and 100 kHz in the FM band.

TUNING KNOB (40)

The tuning steps are 1 kHz in AM/SW and 25 kHz FM.
E5 OPERATION MANUAL
continued
Buttons
buttons enables tuning up
buttons. The tuning
17