Setting The Time - Indel B K BASIC Serie Instrucciones Para El Uso

ENGLISH

SETTING THE TIME

If you press any button from P1 to P4 several times, the display will show the chosen programme and
then the time.
To set the tiem, press P2 and P3 at the same time. The hour digits will start to flash and the display will
show the words "set time".
Press - (P2) and + (P3) to set the right time.
To set the minutes, press P1 and then - (P2) and + (P3).
Press P4 to save the new time setting. The display will show the cur-
rent time.
To set a programme (P1, P2, P3 or P4) on the Minibar, press the button
of the chosen programme for at least 2 seconds.
If the batteries have run out, the display will show this symbol:
Press ON/OFF to turn the Minibar off. The display will show "Off". To enable
the remote control again, press the ON/OFF key.
Attention!
If the mains power supply is cut off for less than 48 hours, the Minibar turns on again using the previously
set program. If the mains power supply is cut off for more than 48 hours, the Minibar will be oper-
ated by the pre-calibrated thermostat. To set a program again, follow the instructions given on THE
REMOTE CONTROL.
Attention!
If the power supply is voluntarily cut off, wait at least 15 minutes before turning the refrigerator on again (i.e.
before connecting it to mains supply). If not, the compressor could be locked for few minutes before
starting its normal operating.
32
K BASIC - K SMART - K ECOSMART
OFF
K BASIC-K SMART-K ECOSMART_20-11-2017
SET TIME
TIME