Setting The Time - Indel B KD 50 ECOSMART Instrucciones Para El Usuario

KD 50 ECOSMART

SETTING THE TIME

If you press any button from P1 to P4 several times, the display will show the chosen programme and
then the time.
To set the tiem, press P2 and P3 at the same time. The hour digits will start to flash and the display will
show the words "set time".
Press - (P2) and + (P3) to set the right time.
To set the minutes, press P1 and then - (P2) and + (P3).
Press P4 to save the new time setting. The display will show the current
time.
To set a programme (P1, P2, P3 or P4) on the Minibar, press the button
of the chosen programme for at least 2 seconds.
If the batteries have run out, the display will show this symbol:
Press ON/OFF to turn the Minibar off. The display will show "Off". To enable
the remote control again, press the ON/OFF key.
Attention!
If the mains power supply is cut off for less than 48 hours, the Minibar turns on again using the previously
set program. If the mains power supply is cut off for more than 48 hours, the Minibar will be operated by the
pre-calibrated thermostat. To set a program again, follow the instructions given on THE REMOTE CONTROL.
Attention!
If the power supply is voluntarily cut off, wait at least 15 minutes before turning the refrigerator on again
(i.e. before connecting it to mains supply). If not, the compressor could be locked for few minutes before
starting its normal operationg.
KD 50 ECOSMART_19-03-2015
ENGLISH
SET TIME
TIME
OFF
37