Before Using - Metabo C 7WDM Manual De Instrucciones

English

BEFORE USING

1. Make sure the power source is appropriate for the tool.
WARNING:
2. Make sure the trigger switch is turned OFF.
WARNING:
Press the trigger switch to turn on the saw; release it to shut the saw off .
After releasing the trigger switch, make sure the trigger switch has gone all the way back
and the switch is turned off .
3. Check the tool for visible defects.
Confi rm that the tool is free of cracks or other visible damage or lack of parts.
4. Confi rm that the saw blade is attached securely to the power tool.
Using the supplied blade wrench, tighten the bolt on the saw blade spindle to secure the
saw blade.
For details, see Fig. 11-a, Fig. 11-b and Fig. 11-c and Fig. 11-d in the section on "Saw blade
mounting and dismounting".
5. Check the lower blade guard for operation.
WARNING:
20
Never connect the power tool unless the available AC power
source is of the same voltage as that specifi ed on the nameplate
of the tool. Never connect this power tool to a DC power source.
If the power cord is connected to the power source with the
trigger switch turned ON the power tool will start suddenly and
can cause a serious accident.
Fig. 13
* Make absolutely sure that the safety cover is not fi xed. Also,
check and see if it can move smoothly. If the saw blade is kept
exposed injury can result.
* If the safety cover should not move smoothly, never use
it without repairing it. In such a case, get in touch with the
metabo HPT Authorized Service Center for necessary repair.
Trigger switch