Mounting The Rotary Table Lock Screw; Installing The Work Clamp; Mains Connection; Operation - Metabo KGS 216 Plus Manual De Instrucciones

 Use a suitable adapter for connect-
ing the dust collector.
 Make sure the dust extractor meets
the requirements specified in the
section 'Technical Data'.
 Also follow the operating instruc-
tions supplied with the dust collec-
tor!
6.2 Mounting the rotary table
lock screw
Insert the lock screw (75) and turn

until tight.
75
6.3

Installing the work clamp

The work clamp can be installed in two
positions:
– For wide workpieces:
insert the work clamp into the rear
hole in the table and secure with the
lock bolt (78):
79
– For narrow workpieces:
loosen the lock bolt (77) and insert
the front part of the work clamp into
the front hole (80) in the table:
Clamping the workpiece:
1. Press and hold down the button
(79) and slide the work clamp
against the workpiece.
2. Tighten the knob (76) to clamp the
workpiece.
6.4

Mains connection

B
Danger! High voltage
 Operate this device only in a dry en-
vironment.
 Operate the saw only with a power
source matching the following re-
quirements (see also 'Technical Da-
ta'):
– mains voltage and system fre-
quency conform to the voltage
and frequency shown on the ma-
chine's nameplate;
– fuse protection by a residual cur-
rent operated device (RCD) of
30mA sensitivity;
76
– outlets properly installed, earthed
77
and tested.
 Make sure that the mains cable is
out of the way so that it does not in-
terfere with the work and cannot be
damaged.
78
 Protect mains cable from heat, ag-
gressive liquids and sharp edges.
 Use only rubber cables of sufficient
cross section (3 × 1.5 mm
tension cables.
 Do not pull on the power supply ca-
ble to unplug.
7.
 Before starting any work, check to
see that the safety devices are in
proper working order.
 Use personal protective equipment.
 Assume proper operating position:
– at the front of the saw;
– facing the saw;
80
– to the side of the line of the saw
A
When sawing ensure that the work-
piece is always clamped with the work
clamp.
Never saw workpieces which can-

not be clamped with the work
clamp.
A
When tilting or swivelling the sawhead
do not reach into the axis area of the
sawhead holder or under the machine!
Hold the sawhead securely when

tilting.
When working use the following:

– work support – for long stock,
– dust extractor.
 Cut only stock of dimensions that al-
low for safe and secure holding
while cutting.
 Always hold the workpiece down on
the table and do not twist it. Do not
attempt to stop the saw blade by ex-
erting lateral pressure to it. Risk of
injury if the saw blade is blocked.
2
) as ex-
7.1
The laser guide is switched on and off
via the switch (81).
It projects a continuous red line at the
position where the workpiece is cut by
the saw blade.
 Carry out a few trial cuts to become
familiar with the functioning.
ENGLISH

Operation

blade.
Danger!
Risk of crushing!
which would otherwise fall off the
table on completion of the cut;

Using the laser guide

29